Metrologic MS5100 Uživatelská příručka stáhnout pdf (Strana 10)

Cable Installation and Removal

Installation

1. Insert the cable’s modular connector into the socket on the scanner.

2. Pull gently on the cable strain relief to ensure the cable is installed.

Note: If the PowerLink cable is not fully latched, the unit can power

intermittently.

Figure 3.

Removal

Disconnect the power supply from the PowerLink cable and turn off power to the

host system before removing the cable from the scanner.

1. Locate the small ‘pin-hole’ on the front

side of the scanner near the end of the

handle.

2. Bend an ordinary paperclip into the shape

shown.

3. Insert the paperclip (or other small metallic

pin) into the small ‘pin-hole’. There will be

a faint ‘click’ when the connector’s lock

releases.

4. Pull gently on the cable’s strain-relief to

remove the cable.

Figure 4.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Žádné komentáře

Metrologic MS5100 Uživatelská příručka Strana 10