Metrologic IS421X ScanGlove Uživatelská příručka stáhnout pdf (Strana 8)

Audible Indicators

Audible indicators show the status of the scanner. These indicators are

dependent upon the decoder being used. The function of these indications may

not work as described below if the decoder pinouts and software controls do

not match the pin out signals as defined in the pin assignment section of this

manual.

To change the volume (four settings are available) or turn the beeper off, refer

to the Programming Guide section: Beeper Tones.

One Beep When the scanner first receives power, the red LED will

blink, followed by the green LED, and then the scanner will

"beep." After the scanner performs this start-up sequence, the

scanner is ready to scan.

When the scanner successfully reads a bar code, the green

light will flash and "beep" once. If the scanner does not

"beep" or the green LED does not flash then the bar code

read is not successful.

Razzberry If, upon power up, the scanner emits a razzberry tone,

Tone then the scanner has failed diagnostics.

Note: The scanner can be programmed to emit a razzberry

tone when the timeout occurs during communica-

tion between the host and scanner. Refer to the Pro-

gramming Guide section: Audible Indicators for

Communication Timeouts.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Žádné komentáře

Metrologic IS421X ScanGlove Uživatelská příručka Strana 8